Magnetic Brake Heavy Duty 24"& 30" Spool Dereeler - No lifting of spool

Itasca Magnetic Brake Heavy Duty Spool DereelerThe unit consists of a Heavy Duty welded frame with bearing mounted shaft. Spool is rolled onto the tensioner and secured with locking device. The tensioner is capable of handling both the 24" and 30" spool with round, square or flat wire. Pictured on the right the no lift heavy duty floor mount with pneumatic dancer arm. No lifting of spool is required, just roll them in!

Design

Welded frame, Roll-In Dereeler uses a Magnetic Particle Brake or Pneumatic Caliper-Disk using a Patented Gear engagement to the spool shaft. Tension is controlled by 0-10 VDC signal, Optional Dancer arm is also controlled using a 0-10 VDC Analog air regulator. Easy change over from one spool to another using a Quik-Loc collar for holding spool in place.

Floor Mount

Larger gages of wire are usually sold in larger packs. Dispensing of Spools can best be accomplished using the Floor Mount Model. Placement of Dereeler could be behind winder or behind the operator if hand winding.

Optional Features

Analog Controlled Dancer Arm.
Spool lift, for elevating spool to wind height.
Pneumatic Caliper and Disk for Brake
Additional Spool Shafts
Other sizes will be quoted upon request.

Technical Data

Both Spool Sizes: 24" & 30" Diameter
Max Tension: 150 Ft. Lbs.
Air Required: 80 Psi. Min.
Max. Spool capacity: 30" spool x10"width
Spool hole size: 1 1/4"-2 1/2" Dia.
Shaft to Floor: 16.0"
Max Spool Weight: 500 Lbs.
Dimensions: 26"Wx48"Hx28"L

Photographs and information featured on this page depict a typical ITASCA SYSTEMS, INC. Magnetic Brake Heavy Duty 24"& 30" Spool Dereeler -No lifting of spool, and may change due to design changes which may be incorporated